Skip to main content
    Heavenly Pools - Pool Supply Direct

    How to Clean a Cartridge Pool Filter

    By Heavenly Pool Supplies · Published

    A cartridge filter traps debris in its pleated filter media. Over time the pleats fill up, flow drops and the pump works harder. Regular cleaning keeps water moving and helps the filter do its job.

    When to clean the filter

    Watch the pressure gauge on top of the filter. Note the reading right after a cleaning, which is your clean starting pressure. When the gauge climbs well above that number, or the return jets weaken, the cartridge is due for a cleaning.

    Tips

    • Always set the cartridge aside on a clean surface so it does not pick up dirt before you reinstall it.
    • Replacement cartridges are model-specific. Match the model number printed on your current cartridge or in your filter manual.
    • Dispose of rinse water according to your local rules rather than draining it back into the pool.

    Steps

    1. Turn off the pump

      Switch off the pump and any automation at the breaker or control panel before you open the filter housing.

    2. Release the pressure

      Open the air relief valve on top of the filter until air stops hissing and the pressure gauge reads zero.

    3. Remove the cartridge

      Open the filter tank following your filter manual, then lift the cartridge straight out. Note how the cartridge and any O-ring sit so you can reinstall them the same way.

    4. Rinse the pleats

      With a garden hose, rinse between every pleat from top to bottom. Work around the whole cartridge and avoid a high-pressure nozzle that can damage the pleated material.

    5. Soak if needed

      If the cartridge feels oily or stays discolored after rinsing, soak it in a cartridge filter cleaner mixed and timed according to the cleaner's label, then rinse it thoroughly.

    6. Let it dry and inspect it

      Let the cartridge dry, then check for frayed, flattened or cracked pleats and for damage to the end caps. Check the tank O-ring for cracks or flat spots.

    7. Reinstall and restart

      Put the cartridge and O-ring back, close the tank, open the air relief valve, restart the pump and close the valve when water flows steadily. Note the clean starting pressure on the gauge.

    Frequently asked questions

    How often should I clean a cartridge pool filter?
    Clean it when the pressure gauge reads roughly 8 to 10 psi above its clean starting pressure, or sooner if flow from the returns drops. Your filter manual gives the exact guidance for your model.
    Can I use a pressure washer on a pool filter cartridge?
    It is not recommended. A high-pressure stream can damage the pleated filter media. A garden hose with a standard spray nozzle is the usual approach.
    When should I replace the cartridge instead of cleaning it?
    Replace it when the pleats are frayed, flattened or cracked, when the end caps are damaged, or when the pressure rises again very soon after a thorough cleaning.